PFF69-502G - PFF69-502G is designed to replace the front lower control arm rear bush and is engineered to provide:-Revised front ANTI-LIFT geometry, On-car CASTER adjustment giving +/-0.33 degrees of adjustment, Improved front traction and reduced understeer, Low compliance ball and socket bush design PFF69-503-18 - Please measure the diameter of the anti roll bar and order the correct size. PFF69-503-20 - Please measure the diameter of the anti roll bar and order the correct size. PFF69-503-21 - Please measure the diameter of the anti roll bar and order the correct size. PFF69-504 - This kit fits Hydraulic Power Steering racks only PFR69-510G - This bush is designed to replace the rear upper control arm front bush and is engineered to provide on car CAMBER adjustment with a range of +/- 1.0 degree, as well as being of a low compliance design. This bush must be used in conjunction with PFR69-511G. PFR69-511G - This bush is designed to replace the rear upper control arm rear bush and is engineered to provide on car CAMBER adjustment with a range of +/- 1.0 degree, as well as being of a low compliance design. This bush must be used in conjunction with PFR69-510G. PFR69-512-14 - Please check anti roll bar diameter before ordering. PFR69-512-16 - Please check anti roll bar diameter before ordering. PFR69-512-18 - Please check anti roll bar diameter before ordering. PFR69-512-20 - Please check anti roll bar diameter before ordering. PFR69-620 - For WRX/STI models 2011-2014 PFR69-621 - For WRX/STI models 2011-2014 PFA100-14 - Our PowerAlign camber bolts replace the original upper bolt on suspension struts with a two-bolt fixing to the knuckle, one positioned above the other, allowing up to +/- 1.75 degrees of adjustment. This kit contains 2 camber bolts, tab washers and nuts. Why not add our Magnetic Camber Gauge to your toolkit so that you can make pit garage adjustments to your suspension using PowerAlign Camber Bolts?
